skippeer

The Plastimo Transocean ISO 4-p type T1A < 24H has been in a cradle hanging on the pushpit since the start in 2017. This year I have a...

failed to delete this item

Yes, new every time.

Mounted a new SS exhaust elbow on a VP D2-55 and used Permatex Red Rtv as a silicone gasket. Cleaned on the outside the silicone that...

Mounted a new SS exhaust elbow on a VP D2-55 and used Permatex Red Rtv as a silicone gasket. Cleaned on the outside and then I started...

This winter did I remove my old 3 blade FOF from the shaft. I read in advance the instructions but when I executed the task did I forget...

Sure that is good product, Devcon as well. I planned just to replace the exhaust elbow as a quick task and suddenly faced corrosion. No...

Before suggesting good ideas based on your local circumstances please reminder I am 3000 km away from my home in a country I only know...

I agree on that this is a temporary solution until the Penta company got time for me to install a new heat exchanger.

I bought it in December 2024. My big mistake was that I applied it in thick layers. The thinner parts cured fine. The JB Weld company...

Yesterday did I got delivery from Amazon.es to the marina reception of JB Weld original epoxy. Removed all traces of JB Weld Extreme...

From memory the exhaust gases will be in the region of 400-500c but the heat exchanger and exhaust flange run way cooler than this and...

I am abroad, no car, no rental car company around.

As a general rule I'd steer clear of marine fabricators / welders for this type of job, although your guy could be an exception. You...

I used the knife now and removed the crap. Have a conversation with a local Penta workshop that only can help me with a new HE even...