Refueler's latest activity

As far as I know - there are no magic solutions for it ..... I can tell you that when the guy was repairing my keel ... any day that...

The Slicer I use on my Repetier and Ender - they do not have some of the better infill geometrys ..... using the supplied Gcodes solves...

Read my post again slowly and digest ..... 12.35 microsecs .... is the radar mile which means in that time = 1852m x2 (it is x2 as the...

Dare I suggest that its wrong time of year completely unless you can get the boat under cover and warmer ... Varnish tends to 'bloom'...

Where are you planning to sail this 22ft boat from ?? Couple months ago there was a ~30ft boat in Ventspils ... they'd sailed from...

I would say that the cable used would likely be the greater influence ... along with connectors. With 25W out of a VHF many people...

Today tested the 'eraser wheel' on that tape residue .... With battery drill - it did not want to - drill too slow. Swapped to mains...

Simply put - yes I was referring to Bambu defaults ... as there are no real defaults with regular printers as I explained. Never...

I have both masthead and pushpit mounted VHF antenna's on my 25ft'r ... a hang over from when I had AIS Rx to the rail antenna. Later...

Measured Miles are I am sure you realise are designed to be made in both directions to average out and negate the tide / current flow.

Why ? Just rotate it 90 and lay flat .... I don't have to 'design' supports ... If needed - I can let the Slicer add them as needed...

I know a few people like that !! I just shrug shoulders .. and move on ... Maybe tell him about Class B+ ??

having been 3D printing for some years now ... there are two areas that I realised were serious factors to obtain good results - before...

Here is an old set of 3D objects I have knocked up ....

I don't know where you get your idea from .... OK ... there are Passive splitters that are only designed for low power on both signals...