PCUK's latest activity

If you're desperate, send me a template and I'll cut it for you and trim the edges with veneer. Nr J27 M5.

Did they send you lots of aerial photos? They did for me.

Mole grips if there is enough to grip or even a pair of pliers, otherwise, as above.

Only that the administrators stated there were no directorial links between the Marine Group and Western Marines. They appear to have...

Western Marinas are hiring. Just seen an ad' for an operations manager at Cardiff Marina. That's sounds even more promising to me!

I'll get one and post it to you if that's any help.

I buy a sheet of hook Velcro, remove the old hook sheet and glue the new one to the old backing pad. I'm cheap as well!

I just replace the hook sheet when it wears out.

If you used Paypal, they are very good once you manage to get through to them.

I've been picking over the news from various sources and found that the administrators say there is no directoral link between any of...

Where are you based? Assuming it is all stainless then It's an easy repair if you are anywhere near J27 M5. In all cases the seller...

One of those low temperature welding rods that work with a blow lamp should do it.

Pool tables are also a problem.

There was an Australian mag' called Australasian Amateur Boat Builder. It was aimed at the real DIY enthusiasts on a budget. I remember...

I recently made a catch for the tailgate of the truck out of 6mm stainless rod using only the vice and a hammer. It is quite a complex...