Neeves's latest activity

You omit to mention the size of the screws You cannot leave the screws 'as is' - you say they corrode - this will not stop. As...

I've never found a Multitool blade that will easily cut stainless. As Roger says, a small grinder is the usual answer.

You can get abrasive, and diamond cutting based for multitools that look like they will ut stainless steel. When cutting stainless...

No. Why do you think I have built my own battery? I've never mentioned that I've built a battery.

Geem, Your new battery looks really neat - you must have done it before, practice makes perfect. :) I assume the network of red wires...

I have the thought most nyloc nuts are re-used - primarily because, at the time, there is not a new one to hand and/or because the...

You would have difficulty taking a slab of Tennants onto a cruise ship, they make money from selling alcohol and I suspect have limits...

You will only be deploying it in challenging conditions - and the means should cater for them. I have not read the article - but good...

Its the same with galvanising - grit blasting as part of the surface cleaning process (removing iron oxide) immediately (minutes) before...

A grit blasted surface finish on metals is always recommended on metal painted surfaces. A rough surface on the prop blades helps the...

I always thought some scratches were good - they allow the primer to key to the metal substrate. You want the finished prop to be...

Yes, I apologise. Wait till you need a new windlass or new chain rode - or buy a new yacht. I could not resist the opportunity :)...

Solid fibre glass can delaminate. Jonathan

Worked for me. Didn't scratch the bronze.

Don't let it dry out like that. Tube worm etc comes off easily when still wet from the sea. I polish my prop with a wire cup brush held...