iamtjc
Reaction score
23

Latest activity Postings About

    • iamtjc
      iamtjc replied to the thread How long do latex gloves last?.
      I use latex gloves where I can for jobs not involving solvents and nitrile for the tougher ones. This to minimise the disposal of...
    • iamtjc
      iamtjc replied to the thread What is it?.
      It's an arm to mount a screen/TV
    • iamtjc
      iamtjc replied to the thread Jamming Cleat.
      Thanks everyone for your contributions. Particular thanks to Gixer for the photos of his Hunter which show the exact setup I have but...
    • iamtjc
      I have a jamming cleat on my boat to secure the jib sheet, I have always found it a right pain being very difficult to extract the...
      • IMG_5387 sm.jpg
    • iamtjc
      iamtjc replied to the thread Dremmel woes.
      I formed the impression when I was looking at Dremmel type devices a few years back that Proxxon ones were more robust (at a price). I...
    • iamtjc
      I had an issue once where the cable had become unseated at the morse controller. Probably from chucking fenders in the locker without...
    • iamtjc
      iamtjc replied to the thread CAV filter issue.
      I struggled with changing my CAV filter, getting the seals to sit right etc. It all became very much easier once I realised I could...
    • iamtjc
      iamtjc replied to the thread Best paint.
      I seem to remember Andy at Boatworks today using a PVA solution (polyvinyl alcohol not the glue) sprayed on as an air excluder to harden...
    • iamtjc
      iamtjc replied to the thread EPOXY - SLOW HARDNER.
      Presumably if it hardens more slowly it will generate less heat (or the same amount over a longer time) so maybe it would allow you to...
    • iamtjc
      iamtjc replied to the thread PSS shaft seal installation.
      I did the same (though I bought rather than made a split clamp). Rather than butt it up to the rotor, I left an exact 1mm gap (using...
    • iamtjc
      The crowded Studland anchorage at lunchtime today. Thank goodness for the eco-moorings.
      • IMG_20240119_122203141.jpg
  • Loading…
  • Loading…
Top