Recent content by dougg

We are based in Denia and would like to find out where the nearest reliable sail loft is. thanks.

that's a great help thanks. Will be in there thus afternoon then!

Our current position is 30 nm north of the Chalki bridge in the Evia channel, and are heading to Zea marina. Apart from karistos, are there any lidls en route?

Does any one know if you check in and out of Bozburun again yet?

The luff of the main that was on the lagoon 440 had a lot of curve cut into it. Im not sure if a sail of a mono will have that much curve. We just need something on a temp basis..

Providing that the luff and foot are of similar length, is there any reason why a main sail off a mono hull cannot be used on a catamaran.

Urgently required. Main sail to fit lagoon 440. Would consider one off 420 , 380

Ahh yes cold showers, thats what is on offer at Sant Cruz de La Palma, along with huge surge, its very un comfortable.

I'm trying to down load gribs using sail grib via the Iridium Go app and am being unsuccessful. The condition is good between the iridium and the galaxy Tab s. Any one any ideas? I can down load gribs over wifi with no problem using sail grib. Thanks.

Barpointltd.com

E visa You can have 6 months in Turkey, ie 180 days. Start your 180 day e visa 3 months before you enter Turkey. Get a new 180 day e visa to start the same day as the old one runs out and use the first 90 days of it.

How interesting, I have the same intermittent problem. Is there a battery in the r 125.

Nobody?

Just trying to get the RayTech software to work with 8.1. I've got the programme installed etc and it all works in simulation mode, as it did in 7 and vp before that. However when I plug in the navionics card reader, with the cf card in it,I keep getting a message saying that I must use the...

Not wanting to hi jack the thread but is anyone using the Shenker unit? Also I've seen an Eco Sistem WM on the net 30lpm for £2995-12volt. Any thoughts on this unit? I made a 220v Wm very noisy and had to run a generator. It is my intention to strip it out and fit and energy recovery model.