Donheist

Need some help. Glue basically melted on our Honwave 2.7 so we Need a new tender. I gather Hypalon is the way forward for the Med...

Ordered. Thank you

Hmm. We Stripped out a lot of complexity introduced by the previous owner (2 alternators, inverter, 2 shore power chargers...

Thank you - good suggestion. I could swap the new one in and get the current one looked at at leisure. Pa thank you for the link -...

As the post above states, 17V indicates a faulty alternator regulator. The batteries may be toast by this stage. A simple solution is...

I’m not sure how you’re monitoring battery charging voltage, but it’s worth doing it with a multimeter direct to the battery terminals...

So checked batteries under load - cranked engine 10s and stayed north of 10v so battery not terminal. Checked all wiring from...

That thought occurred to me too. I am moving my way through the grief cycle and I think I’m reconciled to a new one. Sunk cost fallacy...

I thought the Spanish clamp was the way..but I think it might be time to call it a day as the next post suggests

20 minutes from port under motor we smelled overheating batteries - checked and 17v going to engine battery and service batteries. Back...

The tube on my honwave t27 has parted company with the concave plastic edge that holds the transom. Very annoying after we’ve just spent...

Thank you. In the end we plumped for the 4hp. We are still breaking it in but at half throttle it’s useful in a chop. Feels loads...

I did this the other day. Having ordered some ball bearings to replace the ones I lost. It was a 2 person job and I got my wife to...

That’s interesting that multimeter fine no load but still a problem. will check again and see

Can you tell I’m having a jobs day? I’ve recently reinstalled my wheel pilot having taken it to uk for a service. It’s been off a...