pandos

Yes, very appealing, hope you get it sorted out.

The biggest boat that I've done a three day passage on, single handed, was a 52ft mono. It was bliss. Nothing at all made it...

I think if the job is done properly it should be ok for years... When I get the parts separated I will probably discover the cause of...

Thanks, Have joined that, It's a slow forum with many posts going unanswered. In any case the general advice in terms of the keel is...

I finally got the keel off my boat. I have a few questions about corrosion and preventing it. A stainless steel bracket was fitted at...

Always check the email address... thankfully scammers are often too greedy to buy an email address...

I have been searching around for a guide to replacing the bearings in my Raymarine ST60 (2003) wind vane transducer because the...

I thought I might go for my record on thread resurrection...I am dropping my mast this week and will be examining my new to me easy reef...

If you break the deck into panels using tape it gives you a chance to take a break and will allow you to achieve a better finish...

That reminds me of my friend Harry, he had a simple grave.

I'm thinking of replacing the split charge diode pack with a VSR. My charging sources are 60W solar (via a charge controller), a 15A...

I don't, but some people set rig/shroud tension by stretch measurement method. How would they do it with this product. Are they trying...

If you really want to use tape. This stuff works and lasts years..I patched holes on my deck five years ago and they are still covered...

I bought one for my old boat which I never fitted because I'd need to pipe it to somewhere useful which was too much trouble at the...

I have two engines. One is an old Volvo Penta, which was really a peugeot, I buy the original filter from a Volvo main dealer, which is...