B
Reaction score
187

Latest activity Postings About

    • B
      Bandit replied to the thread Anodes.
      You can get a good electrician the check your boat on its berth, it could be a problem with the pontoon electrics or a near by boat. A...
    • B
      Bandit replied to the thread Anodes.
      Start at the beginning , it has failed due to electrolysis due to a connectivity problem, corroded terminals or slat water on wiring, an...
    • B
      I have have Kohler in my boat now 23 years old apart from servicing, no problems.
    • B
      Bandit replied to the thread Sludge or bug?.
      Most boat fuel tanks are not built with a sump and a stripping ability to remove water, crud etc. Over the years water and general crud...
    • B
      Bandit replied to the thread Sludge or bug?.
      Bug and probably a dirty tank that needs, treating, cleaning and the remaining fuel polished or dumped.
    • B
      Bandit replied to the thread VAT on possible temporary export.
      I did not follow the OP's original Idea 18 months in Med the bring it back to the UK. If new boat is a UK build it is useful too have it...
    • B
      Bandit replied to the thread VAT on possible temporary export.
      I know, it is not quite the Med weather wise but assuming you are a UK resident, You could buy the boat VAT free, moor it in Guernsey or...
    • B
      Bandit replied to the thread Any idea where I can buy these?.
      Normally going back a few years the above waterline skin fittings for sink, shower or deck drains were plastic rather than composite...
    • B
      It has certainly been a wet winter, at least every time it rains people are no longer saying " ah but the ground needs it" !
    • B
      IIRC, The plastic collar that the oar attaches slots through has a rivet stopping it sliding up or down? drill that out and position it...
    • B
      I agree with Oldgit. An impeller when the engine is stopped has a couple of blades distorted and that is where they sit for the winter...
    • B
      Bandit replied to the thread Chain finish.
      Don't use Black it will rust like hell. I have only ever seen galvanised or stainless chain on a yacht. If you are using a windlass...
  • Loading…
  • Loading…
Top