vas

Really pleased with this one - worked first time. The hoop on our Rocna anchor (this is the hoop that ensures that the anchor always...

Hi Vas Yes I printed upright to ensure there was strength in the clip. If I printed flat I'm sure it would snap far too easily!

Are you sure about that?

Mark, I hope you built that as it stands in the pic (plate down) and not with the base down as I don't think it will last v.long base down

Over the last few days, I've been doing a non-boaty print job. I have managed to get my hands on one of the new Radxa X4 SBCs. This is a...

So that little print is for a Classic Style Fairline Squadron. In those days, they secured the A/C vent grilles by creating slots in the...

I can answer that. Say you have deployed 20m (counted 4 marks). The wind blows up a little so you decide to let out 5 or 10m Later...

I have connected my Victron charger/inverter, battery monitor and solar controller to a Victron Cerbo, which in turn display all of the...

Princess drawers something like stops or ?

on a 30m ship, he'll have to be on the bathing platform to see that low though :p

Garmin and Standard Horizon both use standard connectors.

Do not forget that the MMSI number stays with the boat. You should adopt it and advise Ofcom of change of ownership.

I I was left a little shell-shocked at what I found and the detail examination is still to be performed but at 1st glance it looks ok...

v.lucky indeed! is the cylinder/liner of #3 fine?

I think someone up there likes you! It could easily have been a catastrophic failure, a long way from home.