Rhosneigr Gaz
New Member
Morning all
Not sure if this is in the right section but here goes....
I have a 1985 70hp Yam which i've just spent a few quid restoring, it's had.....
1. New charging circuit
2. New prop
3. Refurbed lower leg
4. new steering
5. Heat exchanger cleaned
So in preperation for this years first outing i fired her up, ran 100% on the muffs at home, no problem.
Got her to the beach and fired up no probs again, HOWEVER when i put her in gear she wont take any revs. She goes into gear fine and will spin the prop fine at tickover, however as soon as you open the throttle she just bogs down and dies.
I have in my head that it's a fuel starvation issue, does this sound possible?
Any help would be much appreciated!
Included a pic so we know what motor i'm on about! (Pre resto and looking tatty!)
Not sure if this is in the right section but here goes....
I have a 1985 70hp Yam which i've just spent a few quid restoring, it's had.....
1. New charging circuit
2. New prop
3. Refurbed lower leg
4. new steering
5. Heat exchanger cleaned
So in preperation for this years first outing i fired her up, ran 100% on the muffs at home, no problem.
Got her to the beach and fired up no probs again, HOWEVER when i put her in gear she wont take any revs. She goes into gear fine and will spin the prop fine at tickover, however as soon as you open the throttle she just bogs down and dies.
I have in my head that it's a fuel starvation issue, does this sound possible?
Any help would be much appreciated!
Included a pic so we know what motor i'm on about! (Pre resto and looking tatty!)