Waterline oily scum

tinkicker0

New member
Joined
6 Mar 2008
Messages
11,254
Location
Under a cloud - its just started raining
Visit site
What's the best stuff to shift that orrible tarlike waterline oil scum from a GRP hull. Rubbed it off last year and me fingers bled, took hours.

Anyone know any potions that will do the trick? Going to try a bit of petrol soaked rag tomorrow unless anyone says it doesn't work.
 

Warpa

New member
Joined
5 Sep 2010
Messages
624
Visit site
never experienced anything like that on my hull, i would try tardis or the autoglym version of tar and glue remover available from halfords, or if it really is an oily residue use the autoglym engine and machine cleaner which will disolve it. Not a harsh product like gink or the petrol you are thinking about.

If it remains a bit stubborn use the green side of those cheap multi pack spounges you can buy;)
 

longjohnsilver

Well-known member
Joined
30 May 2001
Messages
18,841
Visit site
My first attempt would be with oxalic acid mixed with wallpaper paste. Paint it on, leave for 5 minutes and wash off. Don't let it set! :(
 

tinkicker0

New member
Joined
6 Mar 2008
Messages
11,254
Location
Under a cloud - its just started raining
Visit site
never experienced anything like that on my hull, i would try tardis or the autoglym version of tar and glue remover available from halfords, or if it really is an oily residue use the autoglym engine and machine cleaner which will disolve it. Not a harsh product like gink or the petrol you are thinking about.

If it remains a bit stubborn use the green side of those cheap multi pack spounges you can buy;)


Thanks everyone. The dark brown scum is the result of peeps pumping oily bilges into the marina with no oil sep filter on the discharge line :mad: contrary to the marina and waterways regulations.
Every so often the water has rainbow colours on it.

I have a Bilgekleen oil separation filter on my light duty primary pump outlet and none on my emergency pump, dunno why others don't do the same. It was only about £60.

After 4 years use, the filter is still clean. Never had cause to use the emergency backup pump system.

309101.jpg


Rant over.
 

nrbx

New member
Joined
11 Dec 2010
Messages
154
Visit site
If you're on about the loverly ouse waterlines... which i assume you are

It is mostly rust from the water, oxalic acid will take it straight off and then polish / wax asap!

I've also found that starbrite black streak removed does a good job sometimes too depending on how thick it is.
 

AndieMac

Well-known member
Joined
24 Mar 2009
Messages
4,516
Location
Tasmania, Australia
Visit site
A slightly diluted mix of G-1000 will clean the black, oily, sooty marks (not rust) from water-line or transoms. The tougher the mark is to remove, use less dilution.
 

Fantasie 19

Well-known member
Joined
23 Mar 2009
Messages
4,488
Location
Chichester, West Sussex
Visit site
never experienced anything like that on my hull, i would try tardis or the autoglym version of tar and glue remover available from halfords, or if it really is an oily residue use the autoglym engine and machine cleaner which will disolve it. Not a harsh product like gink or the petrol you are thinking about.

If it remains a bit stubborn use the green side of those cheap multi pack spounges you can buy;)

...for my bike (pedal type) I use a citrus degreaser when cleaning the chain - magical stuff and smells strongly (not surprisingly) of oranges - might be worth a try as it's not expensive, and I'm assuming not too caustic - from Halfords cycle section..
 
Top