Vp dpe trim reading issue

[Lochlomond]

BTW, it's a 2 man job. The 2nd man gets to drink tea and call out guage readings and encouragement to you

I'm hoping to be the 2nd man, my brother the first ha ha, thanks for the info in previous reply Bruce.

 

[Lochlomond]

I'm on the phone so short reply but advise above is not quite correct.

You trim the leg down max and apply some pressure (approx 15kg). You want to then fit and hand tighten nut. You then get the 2nd person at the helm to tell you the figure and you get it to match the other. In my case -3

Doing it this way meant I did not have to loosen anything outside ie. Cog / Wheel

I may have been lucky but when I popped mine in it was -5 So I had very little adjusting to do and only took 5 mins to adjust once in.

Thanks for the input, hopefully I'll have the same luck as you did, cheers