AlexR
New Member
Hi folks.
I have an issue with my port D4 as follows:
When the engine has been running a while and is warmed up, when she has been in drive and I drop her out of drive into idle then shift back into drive (slow running position) the engine stalls.
However, when the engine is cold I dont see the issue. The engine happily will go in and out of drive without stalling.
Once the engine has stalled it is a difficult to start again and sometimes takes a few tries before she starts.
I have run through the calibration process a couple of times so it is not a calibration problem.
I could switch the HCU's around to see if the problem is HCU related.
Any advice?
I have an issue with my port D4 as follows:
When the engine has been running a while and is warmed up, when she has been in drive and I drop her out of drive into idle then shift back into drive (slow running position) the engine stalls.
However, when the engine is cold I dont see the issue. The engine happily will go in and out of drive without stalling.
Once the engine has stalled it is a difficult to start again and sometimes takes a few tries before she starts.
I have run through the calibration process a couple of times so it is not a calibration problem.
I could switch the HCU's around to see if the problem is HCU related.
Any advice?
