Volvo AD41

ChrisKaye

Well-Known Member
Joined
26 Aug 2004
Messages
882
Location
Wiltshire
www.photobox.co.uk
Just a quick question.
Ive recently replaced an exhaust elbow on my starboard engine (along with half the copper cooling pipework, water pump, rubber hoses, and flushed and rodded heat ex and oil cooler to fix an overheating problem) as the flow through the leg and tell tale squirty thing was down by around half. Looking at it now it does seem quite coked up inside and the hole for the tell-tale is obstructed by around 30% .
So now the starboard engine is brilliant again (full road-test this Fri or Sat, once everyone has buggered off after Cowes week coz I get a bit nervy with all them expensive boats out there) but I am thinking it wont be long before the other side needs replacing. Is it worth having the old one shot blasted or acid dipped or something like that. New one is around £250 whereas shot blast is around £25. It would just save me having to explain another Volspec invoice to the missus as she's been focussing in on my boating expenses lately whereas I could mug the kids (I call it pocket money recycling) for the £25 and no one would be any the wiser.
 
Think ive found my overheating problem, I was just getting the old copper pipework (sea water pump to oil cooler) out of the car to take a pic and bung it on ebay and all this rubbish fell out now that it is all dry ......... (hope this works).........[image]http://www.photobox.co.uk/album/album_photo.html?c_photo=29359312[/image]..............so thats where the bits of old impellors go
 
Top