V/P 290 outdrive

[Dean]

What i'm after is the location of the little triangle anodes on the outdrive.

Mine was not fitted as standard but i have bought some but don't know where they go, other than on the H bracket.

Any offers?????

Dean

 

[spannerman]

As you stated its not stated, but to fit one you need to drill a 4.5mm hole and tap it to 6mm in the web of metal in the H bracket frame on the starboard side of the leg. You will see that a vertical strut comes down from the pivot point and then it has a cross piece that supports the gearbox center section. It sits just in the angle of the web with the long side of the triangle running from 9 o'clock to 12 o'clock if this make sense. Just check on the bolt thread size as its a few years since I fitted one so this is from memory.
regards Steve

<P ID="edit"><FONT SIZE=-1>Edited by spannerman on 16/02/2003 20:16 (server time).</FONT></P>

 

[tr7v8]

Steve,

isn't tappig drill size for M6 5mm? That's what my table gives anyway.

Jim
-------

 

[spannerman]

Like I said I was going from memory, so I think you are more likely to be right on that Jim.

 

[Dean]

Thanks,

Dean