Tri light brass light holder replacement.

[noswellplease]

I planned to replace my trilight but after close examination its just the brass section holding the light is badly corroded, the rest is fine and in fact is much nicer than the replacement variety available today that resembles a glorafied coffee jar....i.m.h.o. I checked a couple of light shops Atlantic Home store etc but can't seem to get the smaller type fitting needed. Any suggestions where I might find a fitting which using araldite or whatever I could make do an so keep my nice brass light?

 

[Chrusty1]

Would this be any good?

http://www.autoelectricsupplies.co.uk/product/459

It seems that they are out of stock at the moment, but they will probably get you one?

 

[noswellplease]

Thanks Chrusty its exactly what I'm looking for. Even the holes appear to match!

 

[Chrusty1]

Your welcome! If they can't get you one in time for when you need it, you could always try trawling through the vintage car parts suppliers? I found that one when I was considering making an anchor light at one time.

 

[noswellplease]

Ahhh they discontinued line. Gotta look again.

 

[Chrusty1]

Sorry /forums/images/graemlins/frown.gif.....still like I said, have a mooch on the internet in the vintage car suppliers websites, might turn up something?

 

[Chrusty1]

[ QUOTE ]
Ahhh they discontinued line. Gotta look again.

[/ QUOTE ]

Sent you a PM.

 

[noswellplease]

Will do that, cheers