truscott
Well-Known Member
I have a TackTick MN100-2 Analog Wind Display that I would like to recalibrate, but can not get the setup page to scroll past UNIT (and for that matter, can't change anything on the Unit page).
I have replaced all of the rubber buttons and the \/ arrow powers the unit on happily. The O button allows me to enter setup, and the < and > buttons work happily when I am changing the backlighting, but for some reason, these are the only functions that I can use.
I recently moved the unit from my other boat and as the masthead wand is slightly off center on this new installation, I would like to recalibrate/recenter it.
Appreciate any and all suggestions.
Cheers, PT
I have replaced all of the rubber buttons and the \/ arrow powers the unit on happily. The O button allows me to enter setup, and the < and > buttons work happily when I am changing the backlighting, but for some reason, these are the only functions that I can use.
I recently moved the unit from my other boat and as the masthead wand is slightly off center on this new installation, I would like to recalibrate/recenter it.
Appreciate any and all suggestions.
Cheers, PT