pappaecho
New member
Clever clogs decided that the sterntube/tiller handle was sloppy and secured with a 12mm bolt. Inspection revealed some wear in the stainless shaft.
I bored the 12mm holes out to 12.7 mm or good old half inch imperial.
I then tried to get a proper stainless 1/2inch bolt, complete with proper shank.. I cannot get one. I can get mild steel, and I can get 1/2 inch fully threaded bolts.
Anybody know where I can get a proper shanked stainless bolt 3 inch long on the S Coast?
I bored the 12mm holes out to 12.7 mm or good old half inch imperial.
I then tried to get a proper stainless 1/2inch bolt, complete with proper shank.. I cannot get one. I can get mild steel, and I can get 1/2 inch fully threaded bolts.
Anybody know where I can get a proper shanked stainless bolt 3 inch long on the S Coast?