ST60 Tridata Problem

[Moody]

I have a problem resetting the shallow alarm on my ST60 Tridata.

I have followed the instructions, ie press depth and speed together then enter the calibration mode, but for the life of me I can't seem to alter the shallow alarm.

Any ideas please.

Neil

 

[Steve Clayton]

Page 29?
http://www.raymarine.com/SubmittedFiles/Handbooks/Instruments/81040_4www.pdf

 

[Moody]

Thanks, yep tried that, followed it to the letter, but still no joy.

Beginning to think there may be a fault with the unit (or the operator).

Neil

 

[Steve Clayton]

Just a thought: do you have a master and slave ST60 and you are trying to set up the slave?

 

[Moody]

Good thinking but it's a single helm set up.

Neil

 

[alan17]

I have not had the same problem but thinking about it you might consider reseting all parameters to the factory defaults and then resetting to what you want. Bit of a rigmarole but if you make a note of your present settings that you wish to retain it should not take too long.

 

[[2068]]

Depth and speed keys enters "user calibration" mode, which is not what you want.

You want Page 4.

Hit Depth.

Then Trip plus Reset BRIEFLY.

Trip to decrease, Reset to Inrease.

Then Trip plus Reset BRIEFLY again.

dv.

 

[Moody]

Thanks for that one.

I'll give that a try when I get down there tomorrow.

Neil