JOURNEYMAN
Member
HI,
This worked perfectly till the other day. Now on boot up, wind direction stuck at 12. o'clock and wind speed shows -----.
Have gone thru the test modes, everything working including NMEA both in and out. have gone over wiring (other than at masthead), all tight and dry. Anenometer still spins and vane still moves on the wind.
If the test mode says all good, is there some way to reset to factory defaults or something? have been thru the manual and cant find anything to point to my problem.
It joins a dataline x box version 2.32.
any thoughts would be greatly appreciated
J
This worked perfectly till the other day. Now on boot up, wind direction stuck at 12. o'clock and wind speed shows -----.
Have gone thru the test modes, everything working including NMEA both in and out. have gone over wiring (other than at masthead), all tight and dry. Anenometer still spins and vane still moves on the wind.
If the test mode says all good, is there some way to reset to factory defaults or something? have been thru the manual and cant find anything to point to my problem.
It joins a dataline x box version 2.32.
any thoughts would be greatly appreciated
J