Seat Sealant

twilliams_34

Active Member
Joined
20 Sep 2009
Messages
49
Visit site
Hi
I have had to remove the rear seat in the cockpit to get it repaired. Having spent ages looking for screws or any fixings that held it on I discovered it was held on with a some type of sealant!

The repair is now complete and I need to fix it back on. Does anyone know what type of sealant I need?

Thanks
Tony

(Sealine S28)
 
Usually a cheap silicone sealant applied in blobs will suffice. Degrease first, apply blobs that will spread out with a bit of pressure and retain in position with a little pressure for a day or so. Acetone is good for degreasing a grp area but NOT recomended for vinyl. Meths is better for degreasing vinyl.
 
Hi
I have had to remove the rear seat in the cockpit to get it repaired. Having spent ages looking for screws or any fixings that held it on I discovered it was held on with a some type of sealant!

The repair is now complete and I need to fix it back on. Does anyone know what type of sealant I need?

Thanks
Tony

(Sealine S28)

Cant tell without seeing it. If it is twangy, it'll be ordinary silicone sealant. If it isn't as twangy and is more stiff-rubbery, it is likely sikaflex 291 which is a polyurethane sealant/adhesive used in general purpose boat fixing/building. It could be sikaflex 292 but that's unlikely - 292 is a very strong polyurethane sealant/adhesive and dries quite stiff - it's the stuff used to seal/glue things like cleats and chainplates to GRP (together with bolts)

Ordinary silicone might be ok but i suspect 291 will be better, for reassembly. Dont use too much though or yu'll never be able to remove the item
 
Thanks for the replies, yes it is more of rubber consistency so will have a look at the 291.
When you say do not use too much would 1" blops (technical term :)) be about right?

Tony
 
if you are going to use silcone its better to use DOW CORNING as it doesn't go hard or turn into powder, Regards
 
Top