paddywackcocker
Well-Known Member
Carrying on from an earlier thread, I’m rebuilding a c120s unit and all is in good order, so a few seals, gasket set and a bearing and all is good.
BUT
The splined input shaft is shot, due to the spline backlash ware.
Does anyone know if the company that did the hexagonal machining job is still doing so and if so the contact details.
Regards
P
BUT
The splined input shaft is shot, due to the spline backlash ware.
Does anyone know if the company that did the hexagonal machining job is still doing so and if so the contact details.
Regards
P
