DonGoodeve
New Member
Hi All
I have an ST4000+ wheel drive installed on my 38' C&C. It has been working well until about 3 weeks ago when it lost the ability to read direction. Troubleshooting so far:
1. Checked all continuity on fluxgate wiring
2. Replaced fluxgate core
3. Cursory check over electronics with aid of a service manual
4. Mistakenly followed the instructions in 'ST4000+ No dockside calibration' to perform a factory reset, and now having difficulties persuading the unit it is an ST4000+ again.
Any informed suggestions are very welcome; very much hoping to bring this unit back to life.
Cheers
Don
I have an ST4000+ wheel drive installed on my 38' C&C. It has been working well until about 3 weeks ago when it lost the ability to read direction. Troubleshooting so far:
1. Checked all continuity on fluxgate wiring
2. Replaced fluxgate core
3. Cursory check over electronics with aid of a service manual
4. Mistakenly followed the instructions in 'ST4000+ No dockside calibration' to perform a factory reset, and now having difficulties persuading the unit it is an ST4000+ again.
Any informed suggestions are very welcome; very much hoping to bring this unit back to life.
Cheers
Don