Prout steering

[mikemacdonald]

Need to replace the trackrod ends on my 1984 Snowgoose, can anyone tell me the make used, it has a number 37TR ? 357L4 male thread, think its imperial where it screws into the cross beam.
Thanks. Mike

 

[boatmike]

Need to replace the trackrod ends on my 1984 Snowgoose, can anyone tell me the make used, it has a number 37TR ? 357L4 male thread, think its imperial where it screws into the cross beam.
Thanks. Mike

I think they are a Ford part. (they are on mine but I built mine meself!)
It's certainly a UNF thread.

After I have had me dinner I wqill see if I have a prout drawing and PM you if I do.

 

[boatmike]

Need to replace the trackrod ends on my 1984 Snowgoose, can anyone tell me the make used, it has a number 37TR ? 357L4 male thread, think its imperial where it screws into the cross beam.
Thanks. Mike

OK Mike, Prout Drawing EL-O2364 dated 15th June 1988 is all I have but I think earlier boats were the same.
Quoted are track rod ends manufactured by Quinton Hazel part no QR1175 LH and RH thread which is 9/16 UNF. These were as used on Ford Cortinas so a Ford agent or better a "unipart" agent should find them from this. Take yours with you to double check they are the same!
Hope this helps. Anything else you need PM me.
Mike

 

[mikemacdonald]

track rod end

Thanks for that, am on to a company that does TRE's, have sent them the dimensions so will add your info
best regards, Mike