peter623918
Member
Hi, got a Kemp mast on a westerly Konsort ,i am trying to pull out all the electrical cables/vhf/wind speed etc which currently appear to run through the centre of the mast as i m am tired of them clanking around in there especially at night,and am going to re route them in trunking on the outside of the mast.
However they all seem so tight top and bottom i cant seem to pull any of them either way. They dont appear to go down the special tubes (which prob arnt big enough anyway?) by the sail track.
The halyards etc run inside as well via special wheels top and bottom ,these all run free
Any ideas ....is there a special clamp in side that i dont know about??
The mast is in situ and do not want to take it down if i can help just to do this little problem
Regards
Peter
However they all seem so tight top and bottom i cant seem to pull any of them either way. They dont appear to go down the special tubes (which prob arnt big enough anyway?) by the sail track.
The halyards etc run inside as well via special wheels top and bottom ,these all run free
Any ideas ....is there a special clamp in side that i dont know about??
The mast is in situ and do not want to take it down if i can help just to do this little problem
Regards
Peter
