Furuno Radar displays mirror image

[Bones]

I have a Furuno Radar setup with a 1833C antenna and an RDP 139 display unit, when I bought the boat the cable from the antenna to the display was not connected, I have connected the cables colour to colour to the DJ-1 plug but the radar image is a mirror image.
Are there a couple of wires that should/could be crossed to sort the problem or can I correct this at the display unit?

 

[lenseman]

This from 9 years ago, I hope it helps:

That's a known software glitch. Which version do you have -- just look at the startup screen. You need to go into installation mode, which you do by holding down the menu key while powering on the unit. Then go to "Installation Setup" and then Radar. Then you will find a menu item for headingt adjustment. Just change it by 180 degrees. Look in the installation manual and it will explain this procedure (how to get to the heading adjustment).


http://www.thehulltruth.com/marine-electronics-forum/34948-radar-image-reversed-furuno-1833c.html



.

 

[Bones]

This from 9 years ago, I hope it helps:

That's a known software glitch. Which version do you have -- just look at the startup screen. You need to go into installation mode, which you do by holding down the menu key while powering on the unit. Then go to "Installation Setup" and then Radar. Then you will find a menu item for headingt adjustment. Just change it by 180 degrees. Look in the installation manual and it will explain this procedure (how to get to the heading adjustment).


http://www.thehulltruth.com/marine-electronics-forum/34948-radar-image-reversed-furuno-1833c.html



.

Thanks David thats a great help, I will try it out.

 

[Bones]

Thanks David thats a great help, I will try it out.

Sorted, Many thanks for your quick response, it was a lot less trouble than I had anticipated.