Chris carter
New Member
Anyone had fault code 13? I have an airtronic D2 it only runs for 5 minutes. It's had a new pump flame sensor. No obvious links in the ducting. Any ideas?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Eberspacher fault code 13
- Thread starter Chris carter
- Start date
QBhoy
Well-Known Member
Seems to be a flame sensor error. If you have replaced, you may need to reset it. Do you have the controller that allows resets and diagnostics
Chris carter
New Member
Yes it's the 80110003 controller and I've erased the code many time but come back each time I run the unit.
QBhoy
Well-Known Member
I’d maybe be tempted to take the sensor out again and clean or make sure it’s clean ?