Condor / tornado .catamaran centre plate

[saltyanchor]

Anyone have this catamaran and willing to send me the measurements of the centre plates? (and even better a photo too.)
I am rebuilding a cat and making all the bits and bobs - I have designed two swivelling plates, but I'd rather build the correct ones. I believe the plates are dropped in from above, slide down grooves in the box, stop at the bottom and swing up or down fro beaching etc.
Thanks if anyone replies.

 

[simonfraser]

rob white in Brightlingsea is bound to know,
very helpfull, his co. on 01206 303 606

 

[ex-Gladys]

Try Andy Webb (AW Sailboats) 07941 940459. He may even have old "scrap" ones available.

 

[saltyanchor]

Thanks, chaps - nm

nm

 

[condor1230]

Do you yet have the dimensions? I have a condor and can photograph the plates if necessary.
Each plate has a short section of tube which is inserted into the hole in the plate and then slid down the groove in the centreboard slot.
The plates are then controlled by an uphaul eleastic and a downhaul back to jambing cleats within reach of the crew /forums/images/graemlins/smile.gif