About Time
Well-Known Member
Hi,
I am in the middle of changing the bellows on my DPG drive and decided to do also the coolant water inlet hose (part # 876632). From the inside of boat - on the back of the transom I need to tighten 2 hexagon screws (part # 955516) to hold this hose in place. Does anyone know the torque needed for these hexagon screws ?.... I am a little nervous to tighten too much as the transom I guess is Alloy .. but need to make sure the fit is water tight ... 10 Nm ?? - Thanks for feed back guys.
I am in the middle of changing the bellows on my DPG drive and decided to do also the coolant water inlet hose (part # 876632). From the inside of boat - on the back of the transom I need to tighten 2 hexagon screws (part # 955516) to hold this hose in place. Does anyone know the torque needed for these hexagon screws ?.... I am a little nervous to tighten too much as the transom I guess is Alloy .. but need to make sure the fit is water tight ... 10 Nm ?? - Thanks for feed back guys.