beneteau antares 1080

[derekh]

I was wanting to purchase a couple of new props for my Antares 1080. powered by twin kamd44's. The boat is in the water so without a lift out I cannot see the original sizes. I contacted Beneteau but my email remains unanswered. Probably a long shot, but if anyone has replaced these on a similar boat I would appreciate it if you might share the information on the prop size.
Many thanks
Derek

 

[rlw]

Hi Derek,

I run a targa 40 on KAD 44's with C4 props. I have just had my turbo's replaced and the boat does still seems a bit overpropped with the weight of aircon/genny.
I would expect you to be on C4 or higher. I might be downgrading mine to C3's so if you are interested in a pair of secondhand C4's send me a PM.
Still need to run a test after a turbopressure sensor was replaced.



Rob

 

[MarieK]

Hi Derek,

I run a targa 40 on KAD 44's with C4 props. I have just had my turbo's replaced and the boat does still seems a bit overpropped with the weight of aircon/genny.
I would expect you to be on C4 or higher. I might be downgrading mine to C3's so if you are interested in a pair of secondhand C4's send me a PM.
Still need to run a test after a turbopressure sensor was replaced.



Rob

Antares is on shafts

 

[rlw]

Ah OK KAMD44 then.

 

[jukohaka]

At least with kamd300 configuration, the prop has been

049165 hel.4 pales 470x590 LH45 S8

believe the kamd44 confirm is the same judging from the kamd300 test report and identical speed vs. rpm readings with my kamd44 version (which also in water so cannot check)