nigelmercier
RIP
- Joined
- 20 Jun 2007
- Messages
- 16,234
- Location
- Live in Kent, boat in Canary Islands
Managed to pick up a Lowrance iFinder Go2 for under a tenner on eBay
I had hoped this would have arrived, and I'm keen to make the data cable. I've seen DIY units made with a credit card and some contacts, see this nasty one: http://willcock.pcug.org.au/iFinder_Go.htm
Can anyone tell me the distance between the centre of the two outer pads on the data port?
Would a bit of PCB fit in the slot?
Last edited: