VicS's latest activity

I don't believe the throttle valve can be opening.

The manufacturers' data will tell you the minimum product and substrate temperatures for their products. In cold conditions you also...

The oil will go milky if there is water present. While it remains "clear and bright" you know there is no water ingress

Its not the froth that is important it is the ingress of water that is not acceptable. The critical seals which you will have to...

Why not use a tank vent? There are several alternatives available from Force4: straight, 90deg, 12mm 16mm.

Taking your figure of 60Ah useable capacity, at 12.5 volts that's 750wh or 0.75 kwh. That is half of the usable capacity of the "power...

But the tank must be vented to allow air in as water is drawn out.

I always set self tappers into grp with Araldite. I don't clean the threads, or deliberately make them very slightly greasey, then they...

Tef Gel works by waterproofing the joint. It works best on close fitting joints and screw threads. Duralac is probably too messy for...

The wiring diagram is in the owners manual which can be downloaded from VP's website but it was not straightforward to find Go to...

That is correct The wiring schematic in the owners manual shows the oil pressure gauge sensor and the low oil pressure warning light/...

The "Twist n lock" feature will not help because the pump plunger and handle lift away with the pump top. However the vented loop in the...

It's the inlet that's causing the problem

The downstroke pumps the waste out AND draws water in from outside. The upstroke draws the waste out of the bowl and pumps the flush...

Just to add If fitting a nozzle to take a hose, a Fulham nozzle is the correct one for black low pressure hose, (see the link in #4)...