VicS's latest activity

Same engine as in this very old thread which you have resurrected and hijacked ? Its always better to start you own new thread giving...

Perhaps you could attach a block to the masthead crane and run the topping lift through that or what Oldbloke suggests is the simplest...

My topping lift (19ft Seawych) is attached to the swiveling fitting on the boom end (presumably your mainsheet is attached to the other...

Anything here fit the bill https://www.svb24.com/en/category/floor-latches-hatch-latches-lift-handles-for-boats

Unless they are something special a bearing stockist may be able to help.

There is a good selection to choose from at Rapid Electronics:- buzzers | Rapid Online .

As alex says many have quite a volage range

If it helps . The gas locker drain need not be from the bottom or even at the lowest point of one of the sides. ( Drain openings on the...

Indirectly cooled engines do not have anodes in the cooling circuit any more than your car does. They are protected by the corrosion...

If you have an old one it may be marked on the back

It was not of any value.

deleted

Very lightly oil I said but that is in the very unlikely event that it is an inertia type There are numerous points to lubricate in a...

If you cut the brown wire you will not have any indication of not charging which could be belt failure which will also mean the coolant...

Odd. I'd expect it to be a pre-engage type . If so the mechanical gubbins that engage the pinion with the ring gear need looking at. If...