vas's latest activity

depending on carb setup, getting into the line to the carb may not be enough as Bouba says. Most likely goes to a chamber with a floater...

why, I think J mentioned somewhere that it is 10l/nm at 10-11knots, that's not bad for dunno how many zillion kilos of a palace! Just...

You must be seriously worried, I guess? :ROFLMAO: PS: I'm saying this after experiencing the reaction of mine, while we were onboard...

I was reading the issue yesterday and came across the article. Headed "The 100 Club", I thought that is was an article - something like...

They get more of a what I’d call a varnish which can compromise tiny holes in carbs . Also over time a new set of gaskets won’t go...

Agree with all of this. Raymarine offered the same facility to daisychain their i70 displays, but removed it with the release of the...

remove the gauge, clean cables there, check voltages, fit a temp wire from there to sender - or simpler, remove sender and bring it next...

I'm starting to think so too. I think I have one or two spare NMEA2K cables lying around somewhere. Still baffled though, if say the...

corrosion may be on GND or +12V, leaving bus cable (the other two) passing the signals over. in theory that would mean that it doesn't...

curious, do 4stroke engine carbs gum up? thought it's the 2T ones that suffer this

you really just need to do some very basic fault finding. Swap the device which is not working with one that does. Is it still...

the bus off device, reports TX errors (ie. cannot send data) no receive errors as it obviously wont receive anything if bus is not...

yeah, poor guys go from one support to the other. Lots of idiotic mistakes made, the whole bay has started recovering as around 250tons...

Yes, very common, happened on every charter I've done in last 6 years. All boats return to base for changeover on Sat morning. Diver...

I'd rather not descent from the flybridge on a 45ft boat and run down the side deck to the bow in an emergency, when i can simply press...