TSB240's latest activity

Google-Ergebnis für https://dougedwardsyachts.co.uk/wp-content/uploads/2021/05/IMG_1031-1024x768.jpg. I was very tempted to buy this...

The guard wires on Jazzcat were a bit like the OP's, with signs of rust peeking out from under the plastic. I cut off the plastic and...

Standard swage stud for 4mm wire requires a hole in the stanchion of about 7.5mm, most stanchions will take this but best to check...

Yes - on my boat anyway. Only just.

My boat has standard aluminium stanchions and the swaged studs just fit through.

Another alternative is to have one end fitted with a swaged stud that should pass through your stanchions. You then screw an eye onto...

Yesterday I only had to take the water circulation pump vee drive pulley off before removing the timing belt cover and gaining full...

Running in at berth is a much lighter loading on the engine than pushing a bow wave! I fully sympathise about loosing another season as...

The running in procedure for a new MD 22 took 50hours! This was recommended with boat underway and periods of WOT. Given all the work...

I have the same engine but with a lot fewer hours. It can be quite smokey on cold start but usually clears up after a minute or so...

It doesn't. It is a biocide with a small amount of detergent. It is not either acidic or alkali which makes it safe to use on fabrics...

Patio Magic for me because of its easy availability, but its lookalikes would do as well. I generally treat in situ and let the elements...

I have been trying to source replacement parts for a Jabsco seawater pump as used on many Volvo engines. In the past I have bought these...

We trailered a 24 foot Trapper 240LK and launched on the River Villaine at Foleux. There was no charge for using slip way or for car and...

Two months. 2 litres of It was stored in a 12ltr tank so so space for the good stuff to evaporate and water to be absorbed. It was high...