stelican's latest activity

I don't see why not. The only concern I'd have is that I don't think those sockets are IP66 rated, so I'd make sure they are protected...

No its the other photo but has been answered by Refueler

The scenario is a dayboat that is occasionally left on a mooring and owner wishes to charge batteries via 240v charger and also have...

If you closely look at photo in post 33 you will notice that the inlet fitting appears to be a combined Inlet /PRV and drain valve...

🙄

Tell them you want to buy one but you need to locate faulty one!

Try to speak with Steve Kibble in the parts dept he is very knowledgeable. If he doesn't know he will probably find out.

Don't you mean relief valve on hot side (calorfier)

Yes of course only meant expansion on the hot side. but needs a pressure relief valve.

Right this is a true story, when there used to hot tanks in houses, if the immersion heater over heated it had a expansion pipe that...

Expansion is throughout though

Just looked at photo of calorifier post 33 and it looks like there is a pressure valve on the cold inlet the would work when the...

Interested to hear your views, What is the point of putting one on the cold supply after a stop tap ( never seen a stop tap on the cold...

Yes. It's incorrectly installed if that is cold feed to calorifier and would not allow water into it unless opened as stated by OP

No. You don't need one on the hot water pipe out of the tank as that would only allow over pressure water into the hot water...