Red Panda's latest activity

Thanks again, your experience of having already done this is very helpful. I realised I can’t do software updates without a Raymarine...

The instructions say it must be aligned with the vessel’s longitudinal axis, level, and away from magnetic influence or cables. No...

You may find the the B&G compass will still like to be in a better position, both are nmea2k so I just swapped the connector. Also I...

I can come up with something. I purposely didn’t finalise anything wiring in csse things needed moved around. I’ve now pretty much...

I have a keel stepped mast 😆

VRF does work in sail mode as my mate has just installed his b&g system and this is how he is using it, we’ve just done 3 weeks sailing...

I originally did not have rudder sensor but found a way to add a couple of years ago, ice got tiller with no access to rudder post. What...

Top of quarterberth shelf, just below the side deck. Well away from engine, wiring, compasses. It’s in a very similar position, just...

Thanks Daverw! Have you got a rudder position sensor? The B&G commissioning manual says that I can’t use Virtual Rudder Feedback with...

This is what I’ve just done, all works with the raymarine ram fine, I could not get it to play happy with my new B&G plotter for course...

I would still make the AP stand alone to rule out any issues from stuff on the network. Just put the P70 on the STNG network, with a...

If I can keep just the Raymarine tiller drive and have the rest B&G, it’ll make for a much better overall solution - I’d be able to have...

N2K network: Terminator, Triton display, Vulcan plotter, Ray p70s, N2k power input -> STNG backbone section, with only EV1 and ACU 100...

Easier said than done! I presume I’ll need to connect the EV1 and p70s together, via STNG, but separate from the rest of the N2K...

That was my understanding, so I ran the wizard again, it did as expected.