poultey

Based in Tollesbury for 10 years from 2012 with a 21' bilge keel drawing just under a meter to now having a 31 Moody fin drawing 1.5...

Agree, another alternative. Yes, would be a bit tiring on the tiller in reverse for 2 miles but if the rudder mounts are not up to it I...

Agree, but who would try to do that in UK waters?

Appreciate the reply AntarticPilot. I'll probably try to get under the boat and slacken-off the cutter then make the journey facing the...

I think you're absolutely right and have experienced what you describe on my previous boat ¼ the weight. Also some of the route will be...

N

In my ignorance of the forums layout I believed I hadn't yet posted - wasn't a nudge to elicit a quicker response. And thanks for your...

Recently acquired Moody 31 Mk II, Volvo Penta 2003 28hp, Brunton H5 folding prop. It's necessary to move my boat from one location to...

Walk into Motor factors ... Hi - I have this diesel water separator - can you help me with new seals for it ? Sure .. guy takes item...

You can buy kits ….. Amazon perhaps …… to make nitrile o rings. Kit has different diameters of nitrile and the special glue. Obviously...

I had a separator like that on another boat dating from the 1960s. It had a gauze coarse filter round the spigot in the alloy upper...

There could also be a problem with the fuel tank breather - blocked and creating a vaccum. Easily checked by running engine with filler...

Buy Nitride O rings, you can get them from any motor facrors

A good Motor Factors should be able to match the seal ...

Not readily available and I'm quite taken with the idea of being able to inspect the hull underwater and perform tasks, rope removal...