PCUK's latest activity

You can try a vernier on the outer sides of the coupling flanges.

Sorry, didn't mean to post. Cleaned my keyboard and seem to have over-done the fluid! On the Ipad now. I'm sure someone will buy your...

It may be the reverse lock holding it down. Put the gear lever into forward and try again. If you decide to leave it down, why not...

CT1. Use a smoothing tool for a fine finish.

Have you considered having the Whittal=l=l=l=l=bgkbhr kmo gtc gd=-d=d=d=0-j0 `

Plenty of You Tube videos on polishing. You will need a 3000rpm sander/polisher, Airway buffing wheels and polishing rouge. Total about...

If it's two pack varnish it can be sanded and polished the same as two paint paints. If not, some single pack can be treated the same...

Thanks for your on-site report. I'm feeling a little optimistic. Dredge it and they will come. To paraphrase field of dreams.

Most do.

As Roger says. The hot metal melts into the surface so the only long term solution is to sand back and re-polish.

I keep all my sealants in the freezer and they stay fresh much much longer. You do need to wear gloves when dispensing otherwise your...

Good news J.

Screw the 92mm saw on the arbour, then screw a 60mm saw inside the 92mm saw. Job done.

I disagree. The dredger is very effective, not digger effective, but still good. It cleared a large section of outer harbour a couple of...

Until the gate is working it it still going to dry out and many of the finger berths have been moved to allow better access for the dredger.