Thanks everyone, but I am looking for the measurement between the transducer and the bottom of the props so the depth gauge provides depth under props.
I am considering installing underwater LEDs to my Princess 54 Fly. I have been quoted for these;
OCEAN LED SPORT S3166S
Does anyone have any experience of these, I am interested in how long they last, wull they be powerful enough for UK cruising, colour range, apps or remote. Good or bad...
My experience a few years ago was not good, didn’t expect the extra charges or the weeks lost due to “forgetting” about my job ?. Told the delay to engage forward or reverse was a wiring issue and the only way to fix was to replace the port engine controls wiring loom (thousands of £’s)...
I am looking to complete my passage planning at home and then update a C120W via Navionics CF card. Therefore looking for advise on which software and where to buy the Navionics card reader. Thanks everyone
Does anyone have any advice, recommendations, war stories for someone considering selling their 14m motorboat privately. The value is going to be in excess of £200k, so I am looking for the "do's" and "don'ts" please. Thanks all
Hi All,
I am in the market for a Princess 50 Flybridge MKIII built at the end of the production run, so either a 2012 or 2013 model. I am looking for a boat with low hours, non-charter, fully loaded (AC, updated Navs, Cherry Wood preferred, etc) and properly looked after (loved) by the previous...
Sorry to say it but so long as there are skippers in the hamble that cannot deal with tides you will always be at risk wherever you decide to berth. From deacons to hamble point 2 to 4+ knots of tide will be the reason the other skipper gives. The only logical solution is to go with your...
This pack arrived for me this morning, and at first glance I thought OMG how efficient of Princess sending me a ticket for the 2019 Southampton Boat Show. Upon closer examination I noticed the ticket was for the 2018 boat show (the one that finished 3 weeks ago!). Anyone want to buy this ticket...
Thanks. I am trying to push them down so we can get in to machine off the paint and they won’t go down any further so wanted peoples opinion if they are seized or the movement is normal?