Hi PJ, Thanks for the tip - Unfortunately it's too tall for my installation, especially when the fiddles have to be added to the overall height.
Best, Nudge
Had the boat for nearly 10 years - came with a DL5 fitted but it never fired up. Was always more interested in making the boat go quicker rather than the comforts. Did look at it a few years back and concluded that the fuel wasn't getting through and the pump looked dodgy so put in a new one...
Hi , The original cooker on my Jeanneau was replaced with a Neptune 2000 (I think) but this is 50mm narrower than the space...... So, looking for a cooker hob and oven - grill not necessary but acceptable! - dimesnions approx 500mm wide, 520mm tall to the top of the fiddles, 400mm deep.
I'm in...
Hi Frantzeska, I think we can make that work. As I mentioned I was posting on behalf of a friend who I have now encouraged to join the forum so I will ask him to contact you on this post. Best regards, Nudge. Have PM'd you.
Hi Frantzseko, Not able to PM you, Anyway, I'm in Scotland; whats your location? As I mentioned, my friend who I posted for is looking for a short section so if you were willing to provide a cut off it could be shipped,
Regards,
Hi, Looking for a short section c. 300mm of Selden Boom for an experiment...
Ideally B171 section which is 170mm deep x 90mm wide. As per picture attached.
If anyone knows of a section or broken boom that would be most helpful.
Got a number of torque wrenches but regularly use measured lengths of pipe over the ratchet or spanner pulled with a spring balance. Very accurate and the range is enormous!
Came up with this when torquing up the barrel base nuts on Triumph T150/T160 BSA R3 engines - you can only squeeze a...
Raymaine Autopilot components/ basis for a system:
- Course computer: Type 100 12v unit. Fully tested and working OK £175
- ST6002 Control head £175
- Rudder reference unit: M81105 - new and unused : Fully tested and working OK - Complete with the ball joint mounting kit £120
- Fluxgate...
Just an update on this - Breather free and doingwhat it should.
Filled the tank, closed the fuel cock at the tank outlet and changed the primary fuel filter. Opened the cock & bleed screw..... No fuel coming through to the filter.
Closed the bleed screw and waggled the lift pump toggle a few...