ncritchley

This morning I carried out the first run on my Sea Panther after the top end rebuild, and success! Though with one concerning issue...

And in fact if I put the throttle lever at a midpoint between the two stops, that should be about right I guess. Tomorrow morning I'll...

Good advice, I appreciate this. I don't know why I was thinking of starting it on the fully open throttle setting. I wasn't thinking at...

Thanks Roberto, that's very helpful.

Thanks for this advice. I have actually turned the engine over a good few revolutions both manually and then on the battery to get the...

Thank you!

Apologies, I should have said that mine's the other type. I'll post some pictures shortly.

A long shot, but I don't suppose anyone knows the correct size for the exhaust manifold drain plug? I lost mine during the rebuild, and...

Hi everyone, still needing help I'm afraid. I've got a query regarding the correct positions of the throttle and stop/start levers on a...

There's a fuel cut-off lever on the injection pump. But I'll also have something ready to wrap round the air intake just in case .....

All fine, I found one to measure - 90cm approx. Daft question really..... :)

Does anyone know the code/part number for the drive belt for a Sea Panther (connecting alternator, water pump and crankshaft)? I need to...

Thanks I appreciate the reassurance! I'm going to put a couple of ratchet straps over it to hold it down.....

Hi everyone. I've finished reassembling my Sea Panther (only a top-end overhaul) and I now want to do a minumum setup for a short...