Momac's latest activity

I put a tube heater near the engine on a thermostat that cuts on when the temperature drops to 5 degrees I also drain off all the...

Connected to shore power or not?

I would have thought that depends where the boat is kept and whether ashore of afloat and the risk of frost.

I did replace the ECU on my Eberspacher in 2109. The ECU more than a new Chinese heater at the time but it was an easy fit in that...

Engine

I had the windows in my canopy canvas replaced which resulted in a better fit. Perhaps the windows shrink not just the canvas. But prior...

Could the supercharger electrical connector near the supercharger be disconnected and a multi meter connected to see whether the...

Don't know whether the following might help

Diesels in my case and in the water this winter. I think the discussion is about the fresh water (antifreeze/coolant) cooling system...

I used 50% dilution last time so on reading this thread I may well go with 40% Antifreeze to 60% water this time. I have from a couple...

I would have thought copper coat being an epoxy coating is in itself effective Osmosis protection. For me conventional antifoul is...

It depends on how often it has been abraded to expose fresh copper. I had several layers of copper coat professionally applied, only...

Not at all. Whether going up hill or down the distance travelled is always greater than than the horizontal dimension .

The requirement is independent of the boat/thruster type. Anodes need to be changed when they are roughly 50% down by weight. Rate of...

Its probably run in now.