Hello Donald,
I hope you had good sailing and retuned safely before the storm season started.
I am still interested in this item, so if you have some time, please let me know.
Philip
Hello Donald,
Thank you for your reply. So this is indeed the correct size. See private message for more details.
Don't worry about the timing, since we will not be back home until end of August ourselves. I will be looking forward to your reaction by then.
Happy sailing,
Philip
Hello Donald,
I am looking for an end-fitting like this, but am not sure about the size you specify. As far as I am aware, the smallest size for this type of fitting is o.d. 72mm, so could you please check the o.d.?
Philip
(also: I am living in the Netherlands, what would p+p be?)
Circuit design for hours counter
I installed an hours counter on my instrument panel. All parts can be ordered at rs-online.com. Total costs 40 EUR.
For circuit design, which counts only when the engine is actually running, see: https://www.circuitlab.com/circuit/cc2rfv/hours-counter-driver/.
It is part of the Assy No3. That Assy in itself consists of quite a few parts.
Basically it is the spindle on the left with on the right hand side the planetary gear wheel (with its four axles to carry the gears).
The thicker part of that planetary gear as shown on the picture actually consists...
ST4000+ Ball Bearing
I had this problem with very rough noise as well. It became very scary, and you start to appreciate how important the drive is. In my case, the cause was a failed rollerbearing, not the recirculating balls.
This bearing is part of the planetary gear assy, which can be...
I had similar leakage, but NOT form the arm or O-ring. After long searching, I found that it was one of the two bolts which clamp the control lever to the injector pump! After taking out the bolt, cleaning and sealing with loctite all seems OK for now.
Sensor Replacement
Also my temperature reading became erratic after five years. This winter was the first winter where we left the boat in the water.
I have tested the sensor resistance as described by Raymarine, and it seems to be faulty. I will try to install a separate sensor, tied to a...