ianc1200's latest activity

I had this done with peachments in 2015, installation cost was £2k ex vat then. Engines were 12k ex vat

We bought our Cornish Crabber from Tradewind Yachts at Walsdoorden in 2013 and remember there was a small protected harbour - very...

Can't see Smiths have teak plywood listed. Robbins is £354 + VAT for 8 x 4' 1/4" thick. I am thinking about getting some delivered by...

After we removed the old rotten ends of the two pieces that were affected it was time to cut the ends and glue new pieces on the ends...

Looked into the idea of re-engining a Broom Crown with a pair of Nannis when it was a boat we were interested in back in 2022. Got a...

.......and it rolled like a pig in anything over F2. Moulded by Aquafibre in the 1970s , fitted with a pair of 50 hour M130 HP engines...

With Tru Design it’s good to use the collars ....especially if the fitting is somewhere that can be subjected to lateral forces (ie...if...

bit less power ...

Totally agree re DZR but just to add that DZR fittings and ball valves from ASAP Supplies are very good. I replaced one of mine from...

They have been for over 40 years, long before the material became common in ball valves.

I like Tru Design......but it can be difficult to source the parts (at least here) and you need room inside the boat hull as these...

Thanks for the replies.

Tru Design work well for me Tru Design

Following a purchase survey, I need to replace four sea cocks, these are the inlet & outlet one's for two toilets. It's been mentioned...

So why waste money on the consultation when it was always going to be ignored?