Goldie's latest activity

....am assuming they're not countersunk screws.

Thats the obvious question, are they countersunk or could you grip the edge of the screwheads Thats the obvious question, are they...

If you still have a round had on the pump screws, use a drill chuck to tighten onto the round head and try to undo the screws with a...

Normally they are dome head brass, So nothing will grip the head ,Once the slot in the head breaks they are gone. One may as well file...

Can you put the removed ones back in and tighten them up tight to take the pressure off the stuck screws? Worth a try. I have removed...

Assuming the screws have cheese-heads, I would use good quality* pipe pliers to grip the screwhead and turn them. They will either...

Guidance sought please! I’m trying to do my routine water pump impeller change and can’t remove 3 of the brass machine screws securing...

A boat

Ok, not fin keeled, not keel stepped mast and slightly bigger than the 27/28ft that you envisage but… … my choice would be a Halmatic...

I have a short loop of line cow-hitched to the rings to help pull them over the ram’s horns. It stops my fingers getting caught between...

They do, but we had our old Bromptons (we bought them in 1995) converted by Home Page at a fraction of the price. Other conversions...

Wow, that’s a fair old stretch. I’ll stand by that comment all day long. The damage done to communities in the SW, one poorest areas of...

I will continue to use my out-of-date Imray paper charts, alongside others - I have a sizeable collection of various widespread...

At 25 litres an hour Wansy 'aint goin' anywhere... :ROFLMAO:

Toaster? They use electricity too!