Have a clinker built folkboat that has been completely refurbed last few months.
Carefully prepared and repainted hull in international toplac.
Undercoat went on well.
Several topcoats gave really nice finish.
After several weeks very large number of small blemishes started to appear all over...
Have recently repainted my clinker built folkboat after much prep work and now notice hundreds of tiny bubbles in various places which will need rubbing down and repainting.
What is the cause of the problem
How can I stop it happening again?
Is used for anchor mostly but also used for stepping mast via A frame and pulley mounted on foredeck.
Am told that draw on no load is 45amps. On full load 200amps.
Operating via pulley gives 2.1 ratio.
Have a folkboat that is fitted witj a warrior ninja winch 35spa 12v 1.37kw motor.
Need to rewire but query over gauge of wire to use.needs to be approx 20 ft and I understand that length is a factor in choosing correct gauge.
Any
Purchased a 40 plus engine and decided to replace carb jet to allow 25/1 fuel mix.
Put back together, but after using priming button fuel poured out from the overflow hole in side of bowl.
Is this correct
Ie does holding priming button hold flow open until released and should fuel escape from...
Have just drained the gearbox on my seagull 40 +and all that came out was water!
Have refilled with 140 oil and no apparent leaks at moment but is there a seal that has failed allowing water in?
Have just purchased a seagull 40 plus engine
From 1976 and have been checking everything although it runs well
It has an AMAL carb and want to check if 10/1
Or 25/1 mix.
Apparently the main jet tells you so need to remove and need the tool to do so.
I know radiator keys can be adapted but as I...
Having stripped back the planking above water line on my folkboat all of which is in excellent condition, have applied coat of primer which shows up lots of small blemishes
I need to fill all and then sand back to smooth finish before repriming.
Can anyone suggest an easy sanding one part filler...
Boat is now out of water having seen state of hull underwater,!
Now all cleaned and all seams being resealed with Ct1.
A labourious job scraping all seams back to bare wood before applying ct1.
Why hasnt someone designed an electric tool for shaving paint off of edges of boards below water line.
Thanks guys for all your replies.should have said is clinker built.
Has been in water for couple of months so should have had time to seal.
Sailed it from lowestoft back to ipswich yesterday but had someone on the large manual bilge pump for a lot of the time which on a 12 hr journey was no...
Have just purchased a very nice folkboat but it has issues with leaks in hull.
Basically boat has been out of water over winter and was repainted in spring before going back in water earlier tbis year.
Timber looks to be very sound as inside of boat is not lined and therefore all timber can be...
On a 3ltr mercruiser engine, when trying to start the starter motor just makes a clonking noise most times and motor does not turn .sometimes it connects and starts no problem.
Think the problem is the solenoid which is not always connecting.is this the unit attached to the starter motor or is...
I have a fletcher gts speedboat fitted with a 3ltr mercruiser engine and alpha one outdrive.
The boat is in excellent condition and has a very nice interior.
It has a very good trailer and cover also
I bought the boat about 2 months ago but unfortunately I have now been advised that I have...