Ceirwan

There's a few ways. But I would drill the holes first so I could see from the backside where the backing plate should go. Tape up the...

Epoxy with Colloidal silica or chopped glass if you have it in. But a bit expensive to buy for one job. The easiest thing off the shelf...

This is Seaforce 30M after 11 months in the water.

Those are usually the adverts written entirely in capital letters. Or as a block of text with no punctuation or line breaks. In my case...

Towable genoa cars are certainly better, but they only do what you can do already with your pin stops, just less conveniently. Probably...

Yes & I meant it as such, like I said, I'm talking about cheap boats. Usually priced that way because they need work, are old, need...

Its not just the number that goes up, its the number of people who don't really have any idea about the associated costs, berthing...

Thank for that, Ceirwan. I guess I'm fortunate in having 'rescued' half a dozen sheets/plates of 13mm stuff that 'walks, talks and...

G10, make the thickness about the same as the fastener diameter. It lasts forever and does a better job of spreading the load then...

G10 perhaps.

Nice boat tour of a 39FC

I can't comment on which anti-fouling is most effective, as I have copper coat on my current boat & the last boat was in a mud berth, so...

I can’t give specific recommendations but marinas inland in the Netherlands tend to be much cheaper, having only some stagings with...

Unfortunately the reality of selling a boat at the cheaper end of the spectrum is that you get a lot of time wasters, the cheaper it is...

Trust me, you can buy all of those online, simply by ticking a box to say its going to be for professional use, over the counter may be...