madabouttheboat

Absolutely no need to use any sealant with VP 290 and DP drives.

Could guess as to what is wrong, but get the codes read and you should be pointed in the right direction.

These budget ratchets have 120 teeth. thats more than your typical snap on...

I managed to do it on mine. I can't remember the procedure now though. I do have the pin number written down somewhere, so if you find...

It comes out from the front end, (the end in the picture), as it has a flange on that end of the tube stack, but you do sometimes need...

Thanks all. Seems pretty unanimous. I’m sure I’ll have plenty of other questions as I go down the route of planning and buying.

Looking at installing a solar setup in time for next season and looking at what to buy, in particular in relation to the charge...

If you ever undo a bolt with a non-reversing ratchet spanner, where the head of the bolt gets close to some other component when it...

I used to work on the spanners in a professional capacity. Snap-on is like a cult. I don’t doubt they are good quality, and the lifetime...

Those speed and fuel figures would have been produced with almost perfect optimal conditions. Very lightly loaded boat, perfectly clean...

Thought the same thing. I guess he has either a British or US passport, maybe both, so unless he has gone down the EU ancestor route and...

Second one is probably an alarm sensor. Does your oil pressure light on the dash come on with ignition and go off when the engine is...

I use Tef-gel in any stainless/aluminium connection.